To pair the sensor with your DevKit, follow the Getting Started instructions for Gateway Software Update (RPi) or Gateway Software Update (UltraLite)
If your sensor fails to provide a BLE address to pair with your DevKit, ensure the sensor board is powered either by connecting to a serial power source or by installing a coin cell battery on the sensor.
Note that the Silicon Labs Thunderboard2 sensor goes into power saving/sleep mode after 30 seconds of inactivity. Therefore, we recommend you press the small reset button on the sensor board when you enter Option 3 in the device configuration menu.
If the sensor board is powered and you're still unable to get the BLE address to pair to your DevKit, please contact support@ursaleo.com
Comments
0 comments
Please sign in to leave a comment.